This is probably an easily fixed problem, but apparently I'm an idiot.
i was trying to change the input and after doing so pressed the "set" button, mostly out of curiosity. All the buttons reset to a neutral state, no command. Now I'm unable to change any command :\
Please help!
Cannot change input commands.
Moderator: ZSNES Mods
-
- "Your thread will be crushed."
- Posts: 1236
- Joined: Wed Jul 28, 2004 1:49 am
- Location: Not in Winnipeg
- Contact:
Re: Cannot change input commands.
After you hit set, you are supposed to press the buttons that you want to map to the controls. If nothing is coming up, then there is likely a button that is on perma-press.
<pagefault> i'd break up with my wife if she said FF8 was awesome
-
- ZSNES Shake Shake Prinny
- Posts: 5632
- Joined: Wed Jul 28, 2004 4:15 pm
- Location: PAL50, dood !
Re: Cannot change input commands.
'SET' is for setting the device (which is much more varied in the DOS port).
Once you 'set' the device, you want 'SET KEYS' to configure the whole pad, or click each input box to set its corresponding button/key.
Once you 'set' the device, you want 'SET KEYS' to configure the whole pad, or click each input box to set its corresponding button/key.
皆黙って俺について来い!!
Pantheon: Gideon Zhi | CaitSith2 | Nach | kode54
Code: Select all
<jmr> bsnes has the most accurate wiki page but it takes forever to load (or something)