Cannot change input commands.

General area for talk about ZSNES. The best place to ask for related questions as well as troubleshooting.

Moderator: ZSNES Mods

Post Reply
cyk3

Cannot change input commands.

Post by cyk3 »

This is probably an easily fixed problem, but apparently I'm an idiot.

i was trying to change the input and after doing so pressed the "set" button, mostly out of curiosity. All the buttons reset to a neutral state, no command. Now I'm unable to change any command :\

Please help!
badinsults
"Your thread will be crushed."
Posts: 1236
Joined: Wed Jul 28, 2004 1:49 am
Location: Not in Winnipeg
Contact:

Re: Cannot change input commands.

Post by badinsults »

After you hit set, you are supposed to press the buttons that you want to map to the controls. If nothing is coming up, then there is likely a button that is on perma-press.
<pagefault> i'd break up with my wife if she said FF8 was awesome
grinvader
ZSNES Shake Shake Prinny
Posts: 5632
Joined: Wed Jul 28, 2004 4:15 pm
Location: PAL50, dood !

Re: Cannot change input commands.

Post by grinvader »

'SET' is for setting the device (which is much more varied in the DOS port).

Once you 'set' the device, you want 'SET KEYS' to configure the whole pad, or click each input box to set its corresponding button/key.
皆黙って俺について来い!!

Code: Select all

<jmr> bsnes has the most accurate wiki page but it takes forever to load (or something)
Pantheon: Gideon Zhi | CaitSith2 | Nach | kode54
Post Reply